Spring Push Axial Cable

AX/5/S

Spring Push Radial Cable

AXR/5/S

Spring Push Axial Cable Feather Touch

AT/5/S

Spring Push Radial Cable Feather Touch

ATR/5/S

Pneumatic Axial Cable

AX/5/P

Pneumatic Radial Cable

AXR/5/P

Pneumatic Axial Cable Feather Touch

AT/5/P

Pneumatic Radial Cable Feather Touch

ATR/5/P

Pneumatic Axial Cable Jet

AJ/5/P

Pneumatic Radial Cable Jet

AJR/5/P

Measurement Performance

Measurement Range (mm)

±5

Linearity (% of Reading)

(Note 2)

0.50

Linearity (µm)

(Note 2)

5

Maximum Repeatability (µm)

(Note 3)

0.15

Typical Repeatability (µm)

(Note 4)

0.07

Resolution (µm)

(Note 5)

Pre Travel (mm)

(Note 6)

0.15

Post Travel (mm)

(Note 7)

0.85

Pre Travel adjustment range (mm) (Spring Push Only)

1.50

Tip Force (N)

(Note 8)

Spring Push ±20 %

0.70

Spring Push Feather Touch  ±20 %

0.30

Pneumatic ±20 % at 0.4 bar

0.70

Pneumatic ±20 % at 1 bar

2.60

Pneumatic Feather Touch ±30 % at 0.4 bar

0.18

Pneumatic Feather Touch ±30 % at 1 bar

1.10

Ultra Feather Touch at 0.4 bar

N/A

Pneumatic Jet ±30 % at 1 bar

0.85

Temperature Coefficient %FS/°C

0.01

Electrical Interface (Note 9)

LVDT Sensitivity - Plugged ±0.5% (mV/V/mm)

40

LVDT Sensitivity - Unplugged ±5% (mV/V/mm)

105

Half Bridge Sensitivity - Plugged ±0.5% (mV/V/mm)

14.7

Half Bridge Sensitivity - Unplugged ±5% (mV/V/mm)

51

LVDT Energising Current ±5% (mA/V)

2

Half Bridge Energising Current ±5% (mA/V)

1.2

Environmental

IP65 with gaiter or IP50 without gaiter

-20 to +80

+5 to +80 with gaiter or -10 to +80 without gaiter

cycles depending on application, typical 10 million in most applications

Materials

Stainless Steel

Nylon, Ruby, Silicon Nitride, Tungsten Carbide

Fluoroelastomer or Silicon

steel braided or armoured options available

Note 6: Distance from the fully out position to start of calibrated measuring range

Note 7: Distance from the end of the calibrated measuring range to the fully in position

Note 8: Tip force is at the mid point of the measuring range

Note 9: LVDT probes are calibrated at 3 V, 5 kHz into a 10 kΩ load (100 kΩ unplugged). Half Bridge at 3 V, 10 kHz into a 2 kΩ load (1 kΩ unplugged). The probes will operate at energising voltages between 1 and 10 V and frequencies between 2 and 20 kHz, but the performance is not specified